![]() Clonezilla is fast and reliable except for what appears to be a comm port problem. It appears the cloning process causes the problem. Changing to use a different comm port is not an option. I do not have the problem with any comm ports except COM1. This change works until the workstation has been rebooted then these steps have to be applied again.Īlso, if I perform these same steps on a workstation, I get the same results with the IRQ change. I then go back to see what the settings are. To get the reimaged workstation to open COM1, I open COM1 properties, resource tab, un-check then re-check the "Use automatic settings" box without applying the un-check status.Īfter re-checking the "Use automatic settings", I click OK. When I check COM1 property resources, the problem station looks identical ![]() Please check your port settings." I've checked the BIOS of a working station and compare it to the non-working station. When I use Hyperterminal to test COM1, I get the message "Unable to When I test the unit to make sure all devices work, the printer test will not open COM1. ![]() We have devices set up on specified comm ports. I use Clonezilla to reimage the workstations (yes, we have valid licenses for all units) when we have to replace a hard drive or have warranty work that requires a new install. I have some XP SP2 workstations that are utilized in the plant.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |